.

.

1pc PWM Сигналот на Напон Модул, 0-10V PWM Сигналот да Конвертор на Напон, PWM Конвертира Индустриска Контрола за Јачина на Интерфејс Префрлување

1pc PWM Сигналот на Напон Модул, 0-10V PWM Сигналот да Конвертор на Напон, PWM Конвертира Индустриска Контрола за Јачина на Интерфејс

DEN 1084.80

Количина на стоки
Достапно

Може да се користи за индустриски control panel САЛАДИН или други сигнал интерфејс префрлување.PWM претвора дигитални сигнали во аналоген сигнал (0 до 10 V).Овој модул е лесно да се жица и лесен за употреба.Влезниот дигитален сигнал може да се 5 V или 24 V ниво 0-100% PWM сигналот.Излезниот аналоген сигнал може да биде од 0‑10 V напон.PWM претвора дигитални сигнали во аналоген сигнал (0 до 10 V).Влезниот дигитален сигнал може да се 5 V или 24 V ниво 0-100% PWM сигналот.Излезниот аналоген сигнал може да биде од 0-10 V напон.Може да се користи за индустриски control panel САЛАДИН или други сигнал интерфејс префрлување.Овој модул е лесно да се жица и лесен за употреба.

Карактеристики на понудата

Condition:
100% brand new and high quality
Current:
Max. 12mA
Power supply input voltage:
12-30V
Size:
Approx. 5 x 4.5cm / 1.97 x 1.77inch
Weight:
20g
Quantity:
1pc
Using method:
PWM signal input frequency range:
1KHZ-3KHZ
PWM signal input level range:
4.5V to 10V to level, jumper inserted at 5V. This type signal mainly for conventional industrial control card (such as for board), for 5V the CPU interface. :
12 to 24V to level, jumper inserted at 24V. This type signal mainly for conventional PLC interface :
0-10V analog voltage output explanation:
When the signal input port is not connected, the output port gives 0V. The first time when we power on this module, we better calibrate it:
find a 50% duty ratio signal, connect to DIN-, DIN+, the amplitude matches corresponding jumper. When frequency is at 1kHz ~ 3kHz, use a multi-meter to test AO, GND. The meter should be showing around 5.4V. We adjust the potentiometer on the converter module to make multi-meter shows about 5.4V. After this is done, we have calibrated and matched pulse signal with this converter module.  The module has a definition of 0.1V. Output current 10mA. If duty ratio is in opposite to voltage, we can select PWM output pin STEP LOW / ACTIVE for software.
Package Included:
1 x PWM Signal to Voltage Converter :
After power-up, when there is no input signal, the output is 0V. There is output only when there is input. :

Слични понуди